您好, 歡迎來到化工儀器網(wǎng)
產品簡介
詳細介紹
PEL151-201直流電子負載
www.wuhanyy.com
日本建伍PEL151-201直流電子負載
日本建伍-特點
- 150W/200V/30A；
- zui大輸入電壓200V；
- CC/CR/CP/CC+CV模式可選；
- 10μs~2ms可調率；
- 軟件啟動功能；
- 3點預置；
- 負載轉換功能；
- 100次順序存儲；
- 保護（OVP，OCP，OPP，OHP及RCP）；
- 標準GPIB接口。
日本建伍-技術指標
| Model | PEL151-201 | |
| InputPower | 0-150W | |
| InputVoltage Range | CR Model:0-200V,CC/CP/CV Model:1.5-200V | |
| Input Current Range（Front /RearTerminal） | 0-30A/0-30A | |
| Constant Current Mode | Range/Resolution | LRange:0.3A:0-0.3A/10μA 1.5W max H Range:30A:0-30A/1mA 150W max |
| Accuracy | ±0.2%of SET±0.3% of FS（0-40℃） | |
| Ripple Noise（1MHz） | LRange 1mA rms/H Range 10mA rms | |
| Stability | ±0.1%of FS（typ） | |
| Constant Resistance Mode | Range | HRange:OPEN,1.5k-0.5/ 0.498-50mΩ L Range:OPEN,150k-50/ 49.8-5Ω |
| Resolution | H Range:0.66ms/L Range:6.6μs | |
| Accuracy（23℃±5℃） | HRange:±0.5% SET ±0.15A+Vin/Rin L Range:±0.5%SET ±1.5mA+Vin/Rin | |
| Ripple Noise（1MHz） | L Range:1mA rms,H Range:10m Arms | |
| TemperatureFactor | 1000PPM/℃（Vin=5V） | |
| Constant Voltage Mode | 20VRange/200V Range | 1.5-20V/15-200V（CC+CV Mode,CR+CV Mode） |
| Accuracy/Resolution /Minimum Operating Current | ±0.1% of SET±0.1%of FS（0-40℃）/20VRange: 1mV,200V Ragne:10mV/1% of Constant Current | |
| Constant Power Mode | Operating Range/Resolution | 1.5WRange:0.03-1.5W/50μW 150W Range:3-150W/5mW |
| Accuracy（23℃±5℃） | ±0.4%SET±1.6%FS±Vin* Vin/Rinfor Current L Range）（TEMP factor: 1000PPM/℃（Vin=5V） | |
| RippleNoise（1MHz） | L Range:1mA rms,H Range:10mA rms | |
| Short Mode | SettingCurrent Value | 0.3/30A（V1 model CCOV:18A） |
| SW Mode （Preset A<->B） | Frequency/Accuracy | 1Hz-10kHz/±1.5%SET |
| DUTY/SettingAccuracy/Resolution | 5%-95%/±1.5%SET/ 1%STEP | |
| Through Rate Tr/Tf （1%<-> 100%） | OperatingMode | CC,CR |
| SettingRange | CC:10/20/50/100/200/500/ 1000/2000μs,CR:OFF/200/500/ 1000/2000μs | |
| Setting Accuracy | H:10,20μs:-5μs,L:10, 20μs:±20%,L:50-2000μ :±30% | |
| Soft Start | OperatingMode | CC |
| SettingRange/ Accuracy | 0.1/1/2/5/10/20/50/100ms/±30%set+100μs | |
| Remote Sensing | ? | 2.5Vpar One Way |
| ExternalControl | Voltage | 0-10V（Offset gain Adjustableat Rear Panel.）it takes approx. 1 Second for Settings at CR Mode |
| Resistance | 0-10kΩ（Ittakes approx.1 Second for Settings） | |
| Others | LOADON/OFF,EXT SW | |
| Series/ Parallel （Master/ SlaveOperation） | Connecting Capability | Maximum4 of Slave Units plus 1Master Unit |
| Added CuurentDisplay | Total Value of Slave Units（s） and Master Unitare Displayed at Master Unit Display. Over Write:2 times/Sec | |
| Resolution（L Range/H Range） | 0.1*N/10*N（mA）N:Parallel Unit Numbers. | |
| CurrentMonltor Out | Linearity | ±1%FS（Offsetand gain are Adjustable.） |
| DC CurrentMeasurement | Range/（Resolution） | 0.3/30A（0.1/0mA） |
| Accuracy/Repeat | ±0.2%rdg±0.3%FS（0-4℃）/2Times/Sec | |
| DC VoltageMeasurement | Range/Resolution | 20.000/210.00Vmax（Auto Range）/1mV（0-20V）/10mV（20-210V/,Hysteresis at 18/20V |
| Accuracy/Repeat/ Temperature Factor | 20VRange:±0.03%dgt±0.06%FS,200V Range: ±0.03%rdg±0.03%± 0.03%FS（18-28℃）/2 Times/Sec/±0.003%rdg±0.003%FS/℃ | |
| Power Measurement | Range/Resolution | 1.5/150W（1/100mW）/2Times/Sec（Voltage* Current） |
| UVP（UnderVoltage） | Range/Resolution /Accuracy | OFF,0.5-20V/20mV/± 0.1%SET±40mV（0-40℃） |
| OPP（Over Power） | Range/Resolution | L:0.015-1.65W/10mW, H:15-165W/1W |
| Setting Accuracy | ±0.2%SET±2W（0-40℃） | |
| OCP（Over Current） | SettingRange/Resolution | L:0.03-0.33A/1.5mA, H:3-33A/150mA |
| Setting Accuracy | ±0.2%SET±300mA（0-40℃） | |
| Protection | OverVoltage | Cut Load Off about 230V |
| Over Current,OVer Power | Automatic ResumeAfter 3 Sec of Load Off | |
| Reversed Connection | Terminate by Parasitic FET | |
| Over Heating | Cut Load OFF at 110℃ at Inside Heat Sink | |
| SequenceMemory | Step/Time/ Resolution | 100/50μs-99h59.99995s,PAUSE, PASS/50μs/Cycle:1-255 |
| Items | Discharge Mode Pre-set A,Band C Value,Pre-setA, B and C Switch Selection,Discharge Mode, SHORT ModeON/OFF,LOAD ON/OFF,UVP Setting value, OCP Setting value,OPP Setting Value,SoftStart Setting Value,Tr/Tf Setting value,SW Frequency,SW DUTY,CV RANGE, External Control Mode（PASS at Auto Sequence Mode） | |
| Enviro-mental Request | Temperature/ Humidity | 0-40℃20-85%RH/-20-60℃ 20-85%RH |
| PowerSource/Frequency | AC90-132V/AC180-250V 48-63Hz | |
| Power Factor | Lessthan 75VA | |
| Isolation | Primaryto Body: 1500VAC 1 Minute, Primary to Secondary: 2300VAC 1Minute | |
| Isolation Resistance | Primaryto Body ,Primary to Secondary:500VDC More Than 10MΩ,Secondary to Body:250VDCMore Than 5MΩ | |
| CoolingMethod | Cooling Fan | |
| Dimension/Weight | W*H*D:213*133*450（mm） /Approx.6kg | |