詳細介紹
CVGL73TP3 millipore Durapore 濾芯過濾0.22um
概述
Description | |
---|---|
Catalogue Number | CVGL73TP3 |
Trade Name |
|
Description | Durapore® Cartridge Filter 30 in. 0.22 µm Code 7 |
CVGL73TP3 millipore Durapore 濾芯過濾0.22um
Product Information | |
---|---|
Device Configuration | Cartridge |
Maximum Differential Pressure, bar (psid) | Forward: 5.5 bar (80 psid) @ 25 °C; 1.7 bar (25 psid) @ 80 °C; 0.35 bar (5 psid) @ 135 °C. Reverse: 3.5 bar (50 psid) @ 25 °C |
Maximum Inlet Pressure, bar (psi) | Forward - 5.5 bar (80 psi) @ 25 °C; 1.7 bar (25 psi) @ 80 °C; 0.35 bar (5 psi) @ 135 °C; Reverse - 3.5 bar (50 psi) @ 25 °C |
Cartridge Code | Code 7 (2-226) O-rings w/locking-tabs |
Good Manufacturing Practices | These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices. |
Quality Level | MQ400 |
Biological Information | |
---|---|
Bacterial Endotoxins | Aqueous extraction contains ≤0.5 EU/mL as determined by the Limulus Amebocyte Lysate (LAL) Test |
Media | Durapore® |
Sterility | Other |
Sterilization | 30 SIP cycles of 30 min @ 135 °C; 30 autoclave cycles of 60 min @ 126 °C |
Bacterial Retention | Samples were quantitatively retentive of a minimum Brevundimonas diminuta challenge concentration of 1 x 10? CFU/cm2 using ASTM® F838 methodology. |
Wettability | Hydrophilic |
Physicochemical Information | |
---|---|
Pore Size | 0.22 µm |
Air Diffusion at 23 °C | ≤40 mL/min @ 2.75 bar (40 psig) in water |
Bubble Point at 23 °C | ≥3450 mbar (50 psig) air with water |
Flow Rate | 50 L/min @ 460 mbar ΔP |
Indirect Food Additive | All component materials meet the FDA Indirect Food Additive requirements cited in 21 CFR 177-182. All component materials meet the requirements of the EU framework regulation [1935/2004/EC] regarding materials and articles intended to contact food. |
Non-Fiber Releasing | This product was manufactured with a Durapore® membrane which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6). |
TOC/Conductivity | After sterilization and a controlled water flush of 16.5 L, samples exhibited less than 500 ppb TOC per USP<643>and less than 1.3 µS/cm per USP<645>. |
USP Bacterial Endotoxins | A sample aqueous extraction contains less than 0.5 EU/mL as determined by the Limulus Amebocyte Lysate (LAL) test. |
Materials Information | |
---|---|
Chemistry |
|
Device Material |
|
Seal Material | Silicone (SI) |
Support Material | Polypropylene |
理化信息 | |
---|---|
毛孔大小 | 0.22微米 |
23°C時空氣擴散 | 在水中2.75 bar(40 psig)時≤40 mL / min |
沸點23°C | ≥3450 mbar(50 psig)空氣與水 |
流量 | 50 L / min @ 460 mbarΔP |
間接食品添加劑 | 所有成分材料均符合21 CFR 177-182中引用的FDA間接食品添加劑要求。所有成分材料均符合歐盟框架法規[1935/2004 / EC]中有關與食品接觸的材料和物品的要求。 |
非光纖釋放 | 此產物用的Durapore制造®滿足的標準,“非纖維釋放"過濾器如21 CFR 210.3(b)中(6)所定義的膜。 |
TOC /電導率 | 滅菌和控制水沖洗量為16.5 L后,每個USP<643>樣品的TOC小于500 ppb,每個USP<645>的樣品TOC小于1.3 µS / cm。 |
USP細菌內毒素 | 根據the變形細胞溶解液(LAL)試驗測定,樣品水提取物的含量少于0.5 EU / mL。 |
外型尺寸 | |
---|---|
墨盒標稱長度 | 30英寸(75厘米) |
直徑 | 6.9厘米(2.7英寸) |
過濾面積 | 2.07平方米 |
裝置尺寸 | 30英寸 |
材料信息 | |
---|---|
化學 |
|
設備材質 |
|
密封材料 | 矽膠(是) |
支撐材料 | 聚丙烯 |
包裝信息 | |
---|---|
材料尺寸 | 3 |
材料包 | 雙重易開袋 |
技術指標 | |
---|---|
可氧化物質 | 用水沖洗≥3 L后,將滿足USP可氧化物質測試要求 |
上海登寧科技有限公司是國內專業的實驗過濾材料提供商,致力于將質量、可靠性和操作性突出的產品帶給每一位客戶。
公司產品包括各類濾紙、濾膜、濾器以及輔助器材,主營定性濾紙,定量濾紙,層析紙,玻璃微纖維濾紙;石英濾膜,無機膜,聚碳酸酯膜(PC),聚四氟乙烯(PTFE)濾膜,聚偏二氟乙烯(PVDF)膜,尼龍(Nylon)膜,聚醚砜(PES)膜,醋酸纖維素(CA)膜,硝酸纖維素(NC)膜,混合纖維素膜(MCE);針頭式濾器,囊式濾器,可換膜過濾器,超濾離心管等。廣泛應用于生命科學,農業,藥物醫學,化工,食品,水質分析,環境監測等各個領域,公司與各Q球廠家建立了穩定的合作關系,確保品質的同時更可以滿足客戶對于便捷和實惠的需求。
以客戶為中心是公司生存的根本,專注實驗過濾材料是公司的發展方向,我們將砥礪前行,助力客戶實現更高更快的發展。