国产精品国色综合久久,欧美精品中文字幕亚洲专区,后入内射无码人妻一区

亚洲中文久久精品无码WW16,亚洲国产精品久久久久爰色欲,人人妻人人澡人人爽欧美一区九九,亚洲码欧美码一区二区三区

弗爾德（上海）儀器設備有限公司

400-875-1717轉801

Download

首頁 >> 資料下載 >> O, N determination in steel samples (Inner and outer graphite crucibles)

弗爾德（上海）儀器設備有...

查看電話 在線咨詢

立即詢價

您提交后，專屬客服將第一時間為您服務

點擊提交代表您同意《用戶服務協議》《隱私政策》

O, N determination in steel samples (Inner and outer graphite crucibles)

閱讀：2694 發布時間：2015-05-15

Suitable analyzers
n ON 900
n ONH 2000
Used accessories
n Inner graphite crucibles (90180)
n Outer graphite crucibles (90185)
n Suitable calibration material (NIST or other)
Settings
n Comparator level: 5 mV (low oxygen);
20 mV (other)
n Minimum time: 15 sec (oxygen);
35 sec (nitrogen)
n Maximum time: 3:00 min
n Post waiting: 20 sec
n Base line deviation: 20 mV;
Step: 16 mV; Time: 10 sec
n Mode: continuous
n Outgas
Time: 45 sec
Power: 5 kW
n Time
Purge: 15 sec
Stability: 45 sec
n Integration delay
IR cell: 2 sec
TC cell: 10 sec
n Analyse (1)
Time: 40 sec
Power (1): 4 kW
Power (2): 4 kW
Sample preparation
Make sure that the surface of the steel is free from
contaminations; otherwise clean the sample with
acetone p.a. and let dry at atmosphere.
Procedure
n Prepare ELTRA analyzer (exchange anhydrone,
sodium hydroxide, copper oxide when necessary),
clean furnace, sample drop mechanism, electrode tip
n Run three blanks with empty crucibles
n Calibrate the analyzer with suitable calibration
material (NIST or other)
(1) Fill one empty inner crucible (90180) in one outer
crucible (90185) and place them on the electrode
tip, close furnace (F2 Button)
(2) Weigh calibration material (usually pins)
(3) Place calibration material in the sample
drop mechanism and start analysis (F5 Button)
After analysis give the inner crucible into waste and
fill in a new one. The outer crucibles can be used
approximay 10 times.
Repeat steps (1) – (3) at least three times;
Mark the results and use the calibration function in
the software.

提供商	弗爾德（上海）儀器設備有限公司	下載次數	169次
資料大小	364.4KB	資料類型	PDF 文件免費下載該資料
資料圖片	--	瀏覽次數	2694次