The “F” in FDT Series stands for ‘Flexible Leads’. These are rectangle elements ofpiezo film with silver ink screen printed electrodes. Rather than making the leadattachment near the sensor, the piezo polymer tail extends from the active sensor areaasflexcircuitmaterial with offset traces. This gives a very flat, flexible lead, with a connector at the end. The FDT elements are available in a variety of different sizes and thicknesses.Theyareavailable without a laminate （FDT）, with a laminated （0.005” mylar） on one side （FLDT） or with tape release layer adhesive （FDT with adh） in the sensor area. The connector pinsontheFDTsensors can be directly soldered to a PCB with a reasonable level of care. This component cannot withstand high temperatures （> 80°C）, and therefore coldering of the pins to a PCB must be done quickly. A heatsink clamped to the interface area between the film and the crimps will take the heat away from the film. Pre-tin the pins and then quickly solder them totheboard. Do not allow the soldering iron to touch the film, and do not use a dwelltimeofover5seconds on the pins. Low temperature solder can also be used. 所屬品牌： MEAS
輸出： 0～5V
量程： -
封裝：薄膜元件
工作溫度范圍： 0～70℃
精確度：-
供電電源：無源
特點：無源，安裝方便
類型：壓電薄膜傳感器
電氣連接：電纜連接
典型應用： 傳感區與引出點需要一定距離而又不便于用導線的場合